Very low frequency
Frequency range 3 to 30 kHz
ITU Radio Band Numbers

1 2 3 4 5 6 7 8 9 10 11 12

ITU Radio Band Symbols


NATO Radio bands


IEEE Radar bands


Very low frequency or VLF refers to radio frequencies (RF) in the range of 3 kHz to 30 kHz and wavelengths from 10 to 100 kilometres. Since there is not much bandwidth in this band of the radio spectrum, audio (voice) cannot be transmitted, and only low data rate coded signals are used. The VLF band is used for a few radio navigation services, government time radio stations which broadcast time signals to set radio clocks, and for secure military communication. Since VLF waves penetrate about 40 meters into saltwater, they are used for military communication with submarines. Also known as the myriametre band or myriametre wave as the wavelengths range from one to ten myriametres (an obsolete metric unit equal to 10 kilometres).

Propagation characteristics

Because of their large wavelengths, VLF radio waves can diffract around large obstacles and so are not blocked by mountain ranges, and can propagate as a ground wave following the curvature of the Earth. The main mode of long distance propagation is an Earth-ionosphere waveguide mechanism.[1] The Earth is surrounded by a conductive layer of electrons and ions in the upper atmosphere, the ionosphere D layer at 60 km altitude,[2] which reflects VLF radio waves. The ionosphere and the conductive Earth, form a horizontal "duct" a few VLF wavelengths high, which acts as a waveguide confining the waves so they don't escape into space. The waves travel in a zigzag path around the Earth, reflected alternately by the Earth and the ionosphere, in TM (transverse magnetic) mode.

VLF waves have very low path attenuation, 2-3 dB per 1000 km,[1] with little of the "fading" experienced at higher frequencies,[2] This is because VLF waves are reflected from the bottom of the ionosphere, while higher frequency shortwave signals are returned to Earth from higher layers in the ionosphere, the F1 and F2 layers, by a refraction process, and spend most of their journey in the ionosphere, so they are much more affected by ionization gradients and turbulence. Therefore VLF transmissions are very stable and reliable, and are used for long distance communication. Propagation distances of 5000 to 20000 km have been realized.[1] However, atmospheric noise (sferics) is high in the band,[2] including such phenomena as "whistlers", caused by lightning.

VLF waves can penetrate seawater to a depth of at least 10 to 40 metres (30 to 130 feet), depending on the frequency employed and the salinity of the water, so they are used to communicate with submarines.


A major practical drawback to this band is that because of the length of the waves, full size resonant antennas (half wave dipole or quarter wave monopole antennas) cannot be built because of their physical height. Vertical antennas must be used because VLF waves propagate in vertical polarization, but a quarter-wave vertical antenna at 30 kHz would be 2.5 kilometers high. So practical transmitting antennas are electrically short, a small fraction of a wavelength long. Due to their low radiation resistance they are inefficient, radiating only 10% to 50% of the transmitter power at most.[1] with the rest of the power dissipated in the antenna/ground system resistances. So very high power transmitters (~1 megawatt) are required to radiate enough power for long distance communication.

Transmitting antennas for VLF frequencies are very large wire antennas, up to a mile across. They consist of a series of steel radio masts, linked at the top with a network of cables, often shaped like an umbrella or clotheslines. Either the towers themselves or vertical wires serve as monopole radiators, and the horizontal cables form a capacitive top-load to increase the efficiency of the antenna. High power stations use variations on the umbrella antenna such as the "delta" and "trideco" antennas, or multiply-tuned flattop (triatic) antennas. For low power transmitters, inverted-L and T antennas are used.

To minimize power dissipated in the ground, these antennas require extremely low resistance ground systems. Because of soil resistance, counterpoise systems are often used, consisting of radial networks of copper cables supported several feet above the ground under the antenna, extending out radially from the mast or vertical element.

The requirements for receiving antennas are less stringent, because the transmitter power is generally high to overcome atmospheric noise. Atmospheric noise and not receiver noise determines the receiver signal to noise ratio, so small inefficient receiving antennas can be used. Loop antennas are often used for reception.


The frequency range below 9 kHz is not allocated by the International Telecommunication Union and may be used in some nations license-free.

VLF is used to [1]

In the USA, the time signal station WWVL began transmitting a 500 W signal on 20 kHz in August 1963. It used Frequency Shift Keying (FSK) to send data, shifting between 20 kHz and 26 kHz. The WWVL service was discontinued in July 1972.

The very long wave transmitter SAQ at Grimeton near Varberg in Sweden can be visited by the public at certain times, such as on Alexanderson Day.

Historically, this band was used for transcontinental radio communication during the wireless telegraphy era between about 1900 and 1925. Nations built networks of high power LF and VLF radio stations which transmitted text information by Morse code, to communicate with their colonies and naval fleets. Early attempts were made to use radiotelephone using amplitude modulation and single-sideband modulation within the band starting from 20 kHz, but the result was unsatisfactory because the available bandwidth was insufficient to contain the sidebands.

Naturally occurring signals in the VLF band are used for long range lightning location and for research into phenomena such as transient luminous events. Measurements of whistlers are employed to infer the physical properties of the magnetosphere.

VLF submarine communication methods

High power land-based transmitters in countries that operate submarines send signals that can be received thousands of miles away. Transmitter sites typically cover great areas (many acres or square kilometres), with transmitted power anywhere from 20 kW to 2 MW. Submarines receive the signal using some form of towed antenna which floats just under the surface of the water – for example a BCAA (Buoyant Cable Array Antenna). Modern receivers use sophisticated digital signal processing techniques to remove the effects of atmospheric noise (largely caused by lightning strikes around the world) and adjacent channel signals, extending the useful reception range.

Because of the low bandwidth available it is not possible to transmit audio signals, therefore all messaging is done with alphanumeric data at very low bit rates. Three types of modulation are used:

  • OOK / CWK: On-Off Keying / Continuous Wave Keying. Simple Morse code transmission mode where carrier on = mark and off = space. This is the simplest possible form of radio transmission, but it is difficult for transmitters to transmit high power levels, and the signal can easily be swamped by atmospheric noise, so this is only really used for emergencies or basic testing.
  • FSK: Frequency-shift keying. The oldest and simplest form of digital radio data modulation. Frequency is increased by 25 Hz (for example) from the carrier to indicate a binary “1” and reduced by 25 Hz to indicate binary “0”. FSK is used at rates of 50 bit/s and 75 bit/s.
  • MSK: Minimum-shift keying. A more sophisticated modulation method that uses less bandwidth for a given data rate than FSK. This is the normal mode for submarine communications today, and can be used at data rates up to 300 bit/s- or about 35 8-bit ASCII characters per second (or the equivalence of a sentence every two seconds) – a total of 450 words per minute.

Two alternative character sets may be used: 5-bit ITA2 or 8-bit ASCII. Because these are military transmissions they are almost always encrypted for security reasons. Although it is relatively easy to receive the transmissions and convert them into a string of characters, civilians cannot decode any encrypted messages because they most likely use one-time pads since the amount of text is so small.

PC-based VLF reception

VLF signals are often monitored by radio amateurs using simple homemade VLF radio receivers based on personal computers (PCs). An aerial in the form of a coil of insulated wire is connected to the input of the soundcard of the PC (via a jack plug) and placed a few metres away from it. Fast Fourier transform (FFT) software in combination with a sound card allows reception of all frequencies below the Nyquist frequency simultaneously in the form of spectrogrammes. Because CRT monitors are strong sources of noise in the VLF range, it is recommended to record the spectrograms on hard disk with any PC CRT monitors turned off. These spectrograms show many signals, which may include VLF transmitters, the horizontal electron beam deflection of TV sets and sometimes superpulses and twenty second pulses. The strength of the signal received can vary with a Sudden Ionospheric Disturbance. These cause the ionization level to drop in the atmosphere. The result of this is that the VLF signal will reflect down to Earth with greater strength.

List of VLF transmissions

Callsign Frequency Location of transmitter Remarks
- 11.905 kHz Russia (various locations) Alpha-Navigation
- 12.649 kHz Russia (various locations) Alpha-Navigation
- 14.881 kHz Russia (various locations)
HWU 15.1 kHz Rosnay, France 400 kW. [2]
- 15.625 kHz - Frequency for horizontal deflection of electron beam in CRT televisions (576i)
- 15.734 kHz - Frequency for horizontal deflection of electron beam in CRT televisions (480i)
GBR 15.8 kHz Rugby, England (Regular transmissions ceased April 2003) Many publications listed its frequency as 16 kHz
JXN 16.4 kHz Gildeskål (Norway)
SAQ 17.2 kHz Grimeton (Sweden) Only active at special occasions (Alexanderson Day)
- ca. 17.5 kHz ? Twenty second pulses
NAA 17.8 kHz VLF station (NAA) at Cutler, Maine [3] Transmits occasionally Superpulses
RDL/UPD/UFQE/UPP/UPD8 18.1 kHz Russia (various locations including Matotchkinchar, Russia)[4]
HWU 18.3 kHz Le Blanc (France) Frequently inactive for longer periods
RKS 18.9 kHz Russia (various locations) Rarely active
GBZ 19.6 kHz Anthorn (Britain) Many operation modes, even Superpulses.
NWC 19.8 kHz Exmouth, Western Australia (AUS) Used for submarine communication, 1 Megawatt.[3]
ICV 20.27 kHz Tavolara (Italia)
RJH63, RJH66, RJH69, RJH77, RJH99 20.5 kHz Russia (various locations) Time signal transmitter Beta
ICV 20.76 kHz Tavolara (Italia)
HWU 20.9 kHz Saint-Assise, France [5]
RDL 21.1 kHz Russia (various locations) rarely active
NPM 21.4 kHz Hawaii (USA)
HWU 21.75 kHz Rosnay, France [6]
GBZ 22.1 kHz Skelton (Britain)
- 22.2 kHz Ebino (Japan)
 ? 22.3 kHz Russia? Only active on 2nd of each month for a short period between 11:00 and 13:00 (respectively 10:00 and 12:00 in winter), if 2nd of each month is not a Sunday
RJH63, RJH66, RJH69, RJH77, RJH99 23 kHz Russia (various locations) Time signal transmitter Beta
DHO38 23.4 kHz near Rhauderfehn (Germany) submarine communication
NAA 24 kHz Cutler, Maine (USA) Used for submarine communication, at 2 megawatts. [7]
NLK 24.6 kHz Seattle, Washington (USA) 192 kW. [8]
NLF 24.8 kHz Arlington, Washington (USA) Used for submarine communication. [10]

See also


Further reading

  • Friese "Very low wave reception with ferrite antennas 5-50 kHz

External links

  • Longwave club of America
  • Radio waves below 22 kHz
  • VLF Discussion Group
  • Tomislav Stimac, "Definition of frequency bands (VLF, ELF... etc.)".
  • PC-based VLF-reception
  • Gallery of VLF-signals
  • VLF Receiver
  • VLF radio art, 1
  • VLF radio art, 2
  • VLF radio art, 3
  • World Wide Lightning Location Network
  • Stanford University VLF group
  • University of Louisville VLF Monitor
  • Larry's Very Low Frequency site
  • Kiel Longwave Monitor, VLF/LF real time data
  • Mark's Live Online VLF Receiver, UK
  • IW0BZD VLF TUBE receiver
  • Internet based VLF listening guide with server list
This article was sourced from Creative Commons Attribution-ShareAlike License; additional terms may apply. World Heritage Encyclopedia content is assembled from numerous content providers, Open Access Publishing, and in compliance with The Fair Access to Science and Technology Research Act (FASTR), Wikimedia Foundation, Inc., Public Library of Science, The Encyclopedia of Life, Open Book Publishers (OBP), PubMed, U.S. National Library of Medicine, National Center for Biotechnology Information, U.S. National Library of Medicine, National Institutes of Health (NIH), U.S. Department of Health & Human Services, and USA.gov, which sources content from all federal, state, local, tribal, and territorial government publication portals (.gov, .mil, .edu). Funding for USA.gov and content contributors is made possible from the U.S. Congress, E-Government Act of 2002.
Crowd sourced content that is contributed to World Heritage Encyclopedia is peer reviewed and edited by our editorial staff to ensure quality scholarly research articles.
By using this site, you agree to the Terms of Use and Privacy Policy. World Heritage Encyclopedia™ is a registered trademark of the World Public Library Association, a non-profit organization.